6 x 11 Thin Sheet New Improved Chrome Foil

I have used the BMF1 foil for over 20 years. I noticed on the last few batches that it had a sticker that stated it was new and improved. I have to agree. The adhesive is much better and it is less prone to wrinkling. The new BMF1 Chrome is also less prone to curl when you peel it off of the backing than the BMF7 Ultra Bright Foil. You still need to use a new sharp blade to cut it, but the new changes are great.

I recently used this after years of thinking it was hard to do, to my surprise it was simple yet fun. It gives a realistic chrome shine to all models. Get yourself some tweezers, q tips, and fresh hobby knife. Measure a little wider and longer than what your covering. Use the q-tip to lay it down nice and smooth plus it helps it stick. Now just take your hobby knife and gentle trace the lines and peal off access and your done . I really suggest this it brings life into my model cars

If you are very patient, this product can give you one of the most realistic metal finishes available. It is very, very thin so it shows up every detail in the plastic underneath. It also shows every flaw in the plastic, including sanding scratches. The model must be smooth to about 320-400 grit before the foil will look good on it. Because the foil is very thin, it is also very fragile. It has to be worked down with a light touch until it is well stuck down. Be prepared to peel off and replace some sections until you get the touch. Works best on bare, unprimed plastic. Great for automotive trim, but these very small pieces will add an extra level of frustration until you get it right. Keep at it, though, the results will be well worth it!