Community > Members > jimwoodward1943 (Broken Arrow, OK) > Product Reviews
1-20 of 73
1234Next Page
A tip for the builder Step 2 - do not attach until step 15. The rear axles are narrow and therefore weak. At this point I used Titebond II premium wood glue on the rear axles and then allowed 24 hours....
Accurate with the details; a fun build; fun to airbrush; what can I say other than what the other modeler said - I recommend this kit....
Very precisely molded add-ons for tanks, vehicles, and/or dioramas. Precise down to the trigger on the 1919 MG. Ammo belts are very good and help adorn the MGs. Recommended by me.....
Lots of small parts that are too small for my old fat fingers. Some of the small parts are not needed and become fiddly - other than those complaints all was well. I would not build this again.....
Simple instructions; minor flashing; sprue part numbers difficult to read; builder must determine the order of assembly as the instructions lack steps in assembly.....
The axels for the road wheels were too short for the outer row, i.e., the axels could not engage the outer bank of wheels so some improvisation was necessary. This caused me to use only 8 sets of the....
A challenge at my age especially with my large fingers. The parts fit well and no flashing. Some of the parts were too small for me to do a proper fit and some parts are not mentioned on the instruc....
Do not leave the store without a bottle or two. Great for airbrushing!....
I'll keep this short to the chagrin on my fans. I liked its looks, I bought it, I built it and I still like it. Tried the link to link tracks and liked them too. Try it you'll like it....
It is a Tamiya, what else can be said? Well the decals were not well located on the instruction sheet and some of the numbered parts on the sprues are difficult/impossible to read. The small decals ....
Got too many contours on your build? Mark Fit will make decals conform to any contour found on a model. I highly recommend it to any builder faced with any decals....
All parts fit well without flashing. Detailed can't-go-wrong instructions. Great selection of decals. I added British Insignia from a Matilda kit. Looks great to me and I highly recommend this eas....
For the price and the details it is great. I photocopied seat belts for this kit and used them in the cockpit for an extra feature. Small amount of flashing but easily overcome. Instructions are ea....
Perhaps one of the more unusual airplanes from WWII - great details and easy-to-follow instructions. I would build this one again but use a different camo scheme. People that see it are very complem....
I use this to mask areas where curves are tight and otherwise difficult to mask. Works very well so don't be caught without it when you are at a challenge point!....
All parts fit like a watchmaker's dream. Unbelievably close tolerances and clear instructions. minimal flashing it any exists and I could not find any. Decals for different countries. Best made kit....
Great details on this kit. I would order another one or recommend it to anyone wanting to have an array of armor from the warring countries of WWII. Fine details but the line drawings can be a littl....
Part numbers on the sprues are hard to see and some of the instructions make no sense and the prints should be twice the size and real colors should be suggested other than numbers and shades of grays....
The only negative is there are no part numbers on the sprues and it is difficult to match the smaller parts with the line drawings on the instruction sheets. I wish the model makers would make the in....
Rocket tubes were too wide to properly fit the support stanchions - was going to remove 6 tubes to more properly fit the turret but gave up trying to piece the tubes and went with just the tank - good....
1-20 of 73
1234Next Page
Scroll down to auto-load Next Page