In Stock Building Supplies Gallery Images

This is the 1.35fl oz (40ml) Bottle of Tamiya Panel Line Accent Paint in Clear Black.

This is a 3/4 Oz. Glass Paint Jar with Cover from Badger.

This is a 250ml Bottle of Tamiya color Acrylic Paint (Thinner).

This is a 5/8oz Tube of Cement for Plastic Models from Testors. For Ages 8 and Up.

This is the Rivet Maker Tool from Trumpeter.

100ml Can of Tamiya TS-13 Clear Synthetic Lacquer Paint.

180ml Spray Can of Tamiya's Surface Primer L (White) for Plastic and Metal.

This is a 5/8oz Tube of Fast Wood Cement for Wood Models from Testors.

INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ should also be used. To prevent premature curing, don't spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out. .

Extra-thin plastic model cement with applicator brush. Used to glue parts already held together. The thin glue will wick into the joint for a firm bond.

This is a Coarse Grit Sanding Stick from Squadron Products.

This is a 1/2 oz (14.7mL) glass jar of Flat Black Acrylic Paint from Testors.

This Package Contains an 8 Ounce Assortment of Styrene Pieces (Odds & Ends) for Your Scratch Modeling Needs from Evergreen Scale Models.

23ml Jar of Tamiya XF-1 Black color Acrylic Flat (Matt) Paint.

23ml Jar of Tamiya XF-2 White color Acrylic Flat (Matt) Paint.

INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ should also be used. To prevent premature curing, dont spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out. .

Plastic Model glue with applicator brush.

This is a 1/2 oz (14.7mL) glass jar of Enamel Olive Drab Paint from Testors.

180ml Spray Can of Tamiya's Surface Primer L (Gray) for Plastic and Metal.

This is a 1/2 oz (14.7mL) glass jar of Enamel Aluminum Paint from Testors.