Building Supplies
Shop online for over 12,000 building supplies at discounts up to 88%. Paints is the most popular of the 14 building supplies categories, then Glues, and Hand Tools. Tamiya is ranked #1 out of 145 building supplies manufacturers, followed by Vallejo Acrylic Paints, and Testors.
Sub-Categories for Building Supplies
Products of Building Supplies
Quik-Cure 5min Epoxy 9oz
$22.99 $18.29
Tamiya # tam81301
Add To Cart | Wish List |
23ml Jar of Tamiya XF-1 Black color Acrylic Flat (Matt) Paint.
Tamiya # tam87038
Add To Cart | Wish List |
Extra-thin plastic model cement with applicator brush. Used to glue parts already held together. The thin glue will wick into the joint for a firm bond.
Tamiya # tam87131
Add To Cart | Wish List |
This is the 1.35fl oz (40ml) Bottle of Tamiya Panel Line Accent Paint in Clear Black.
Tamiya # tam81040
Add To Cart | Wish List |
This is a 250ml Bottle of Tamiya color Acrylic Paint (Thinner).
Testors # tes1149tt
Add To Cart | Wish List |
This is a 1/4oz (7.5ml) glass jar of Enamel Paint from Testors.
Website security verified by GoDaddy
Vallejo # vlj73191
Add To Cart | Wish List |
This is the 35ml Bottle Mud & Sand Pigment Powder Set (4 Colors) from Vallejo Acrylics.
Tamiya # tam87042
Add To Cart | Wish List |
180ml Spray Can of Tamiya's Surface Primer L (Gray) for Plastic and Metal.
Tamiya # tam87044
Add To Cart | Wish List |
180ml Spray Can of Tamiya's Surface Primer L (White) for Plastic and Metal.
Testors # tes3501
Add To Cart | Wish List |
This is a 5/8oz Tube of Cement for Plastic Models from Testors. For Ages 8 and Up.
Vallejo # vlj70203
Add To Cart | Wish List |
This is the Vallejo 17ml Bottle WWII American Armour & Infantry Wargames Paint Set (6 Colors).
Tamiya # tam81302
Add To Cart | Wish List |
23ml Jar of Tamiya XF-2 White color Acrylic Flat (Matt) Paint.
Hobbylinc # hlc107
Add To Cart | Wish List |
INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ should also be used. To prevent premature curing, don't spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out. .
Tamiya # tam87064
Add To Cart | Wish List |
180ml Spray Can of Tamiya's Fine Surface Primer L (Gray) for Plastic and Metal.
Alclad # alc107
Add To Cart | Wish List |
This is the 1oz. Bottle Chrome Lacquer for Plastic by Alclad II.
Testors # tes1139tt
Add To Cart | Wish List |
This is a 1/4oz (7.4ml) Glass Jar of Semi-Gloss Black Enamel Paint from Testors.