Building Supplies

INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ should also be used. To prevent premature curing, don't spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out. .

This is a 5/8oz Tube of Fast Wood Cement for Wood Models from Testors.

23ml Jar of Tamiya XF-1 Black color Acrylic Flat (Matt) Paint.

Extra-thin plastic model cement with applicator brush. Used to glue parts already held together. The thin glue will wick into the joint for a firm bond.

This is a Five Piece Tweezer Set from Zona Tool Co.

This is a Grip-On Knife (Assorted Colors) from Excel.

This is the 1.35fl oz (40ml) Bottle of Tamiya Panel Line Accent Paint in Clear Black.

The Model 250 single action, external mix, bottom feed spray gun is great for any job requiring a simple, yet effective spray. The Model 250 is basic enough for children, (ages 8 and up) to use with minimal adult supervision, yet effective enough for adult use. This gun is perfect for jobs requiring large overall coverage with medium to heavy viscosity materials. Modeling, school projects, home improvement projects, workshop jobs, ceramic underglazing, fogging, texturing and stenciling can all be handled by the Model 250. The spray pattern can be adjusted from ¾" to 2" simply by turning the paint tip. The Model 250 uses ¾ oz. or 2 oz. capacity jars. .

This is a 250ml Bottle of Tamiya color Acrylic Paint (Thinner).

This is a 3/4 Oz. Glass Paint Jar with Cover from Badger.

This is a 6 Meter Roll of 6mm Tamiya Masking Tape Refill.

180ml Spray Can of Tamiya's Surface Primer L (White) for Plastic and Metal.

180ml Spray Can of Tamiya's Surface Primer L (Gray) for Plastic and Metal.

This is a 5/8oz Tube of Cement for Plastic Models from Testors. For Ages 8 and Up.

This is a 1/4oz (7.5ml) glass jar of Enamel Paint from Testors.

23ml Jar of Tamiya XF-2 White color Acrylic Flat (Matt) Paint.

INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ should also be used. To prevent premature curing, dont spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out. .

180ml Spray Can of Tamiya's Fine Surface Primer L (Gray) for Plastic and Metal.

These Gray Styrene Plastic Handrails.

Replacement top that is on all of BSI's non-Pocket CAs.