41-51 of 51 results in Building Supplies > Glues : Hobbylinc

Hobbylinc Glues

51 Hobbylinc Glues - Page 3 Products

Hobbylinc INsta-Cure Pocket CA 3/4 oz. Super Thin CA W/Pin in cap Hobby CA Super Glue #131
24%
Off

INsta-Cure Pocket CA 3/4 oz. Super Thin CA W/Pin in cap

Hobby CA Super Glue

$4.99
$3.79
 
In Stock
Earn
108
Rewards
Hobbylinc #HLC131. INSTA-CURE has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam. At the moment CAs cure, they give off a vapor that can irritate the nose and eyes, so be prepared. Thin CAs work very well on balsa since they penetrate into the wood and form more than just a surface bond.
Location : CA Super Glue
Hobbylinc Inst-Cure+ Pocket Ca 1/4oz. Gap Filling CA W/Pin in cap Hobby CA Super Glue #133
26%
Off

Inst-Cure+ Pocket Ca 1/4oz. Gap Filling CA W/Pin in cap

Hobby CA Super Glue

$4.99
$3.69
 
In Stock
Earn
105
Rewards
Hobbylinc #HLC133. INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ should also be used. To prevent premature curing, don't spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.
Location : CA Super Glue
Hobbylinc Maxi-Cure Pocket CA 3/4 oz Extra Thick CA W/Pin in cap Hobby CA Super Glue #135
24%
Off

Maxi-Cure Pocket CA 3/4 oz Extra Thick CA W/Pin in cap

Hobby CA Super Glue

$4.99
$3.79
 
In Stock
Earn
108
Rewards
Hobbylinc #HLC135. MAXI-CURE extra thick CA is the best CA for most plastics, including GE's Lexan MAXI-CURE is the best choice for plastic model assembly. When used with INSTA-SET, it works better than any putty for modifying or filling voids. It can be carved with a knife or razor blade and sanded and feathered to form a finish indistinguishable from plastic.
Location : CA Super Glue
Hobbylinc Insta-Cure Pocket CA 4 oz. Super thin CA W/Pin in cap Hobby CA Super Glue #132
24%
Off

Insta-Cure Pocket CA 4 oz. Super thin CA W/Pin in cap

Hobby CA Super Glue

$16.98
$12.89
 
In Stock
Earn
367
Rewards
Hobbylinc #HLC132. INSTA-CURE has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam. At the moment CAs cure, they give off a vapor that can irritate the nose and eyes, so be prepared. Thin CAs work very well on balsa since they penetrate into the wood and form more than just a surface bond.
Location : CA Super Glue
Hobbylinc Super-Gold+ Pocket CA 3/4oz Foam Safe CA W/Pin in cap Hobby CA Super Glue #139
24%
Off

Super-Gold+ Pocket CA 3/4oz Foam Safe CA W/Pin in cap

Hobby CA Super Glue

$12.49
$9.49
 
In Stock
Earn
270
Rewards
Hobbylinc #HLC139. SUPER-GOLD and SUPER-GOLD+ are our odorless INSTA-CURE CAs They are non-frosting and take only 2 or 3 seconds longer to bond. The Pocket CAs feature a new top that has a pin built into the cap that covers the nozzle. This pin seals the bottle so that if it is tipped over, the bottle will not leak. This makes the Pocket CAs ideal for keeping in your tool or field box, just like our IC-Gel. One disadvantage that the new Pocket CA top has is the bluntness of the nozzle. This makes it more difficult to apply small amounts of the CA, especially in tight places.
Location : CA Super Glue
Hobbylinc FINISH CURE 20 Minute Epoxy (4 1/2oz) Hobby Epoxy #209
20%
Off

FINISH CURE 20 Minute Epoxy (4 1/2oz)

Hobby Epoxy

$11.99
$9.59
 
In Stock
Earn
273
Rewards
Hobbylinc #HLC209. FINISH-CURE 20 min. epoxy is an excellent, low odor substitute for polyester resins. It can be used for applying fiberglass cloth to wood or by itself to give wood a surface ready for primer and paint. FINISH-CURE can be sanded the easiest of all our epoxies and is excellent for the sheeting of foam core wings. Allow 8 hours for full curing. For best results, FINISH-CURE should be heated to a temperature above 85 degrees F or applying light weight fiberglass, lay cloth on balsa first, then brush on FINISH-CURE. When fully saturated, go over the surface with a heat gun, and then squeegee off excess epoxy with a playing card from an old deck. Heat and remove excess several times for a light we
Location : Epoxy
Hobbylinc Foam Cure 1 oz EPP Foam Glue Hobby CA Super Glue #141
16%
Off

Foam Cure 1 oz EPP Foam Glue

Hobby CA Super Glue

$2.99
$2.49
 
In Stock
Earn
71
Rewards
Hobbylinc #HLC141. This is a crystal clear EPP Foam Glue that has a flexible foam-cure unlike other CA glues that stiffen.
Location : CA Super Glue
Hobbylinc IC-LOC - Blue 1/3 fl oz Medium Strength Thread Locker Hobby CA Super Glue #171
21%
Off

IC-LOC - Blue 1/3 fl oz Medium Strength Thread Locker

Hobby CA Super Glue

$5.99
$4.69
 
In Stock
Earn
134
Rewards
Hobbylinc #HLC171. Threadloc Blue is a medium thickness, medium strength threadlock that is applied to the threads of fasteners before assembly. Once the IC-Loc Blue is cured, the fasteners can be disassembled with standard hand tools if required.
Location : CA Super Glue
Hobbylinc Plastic Cure 1/3 oz Brush on Gap Filling CA Hobby CA Super Glue #105
12%
Off

Plastic Cure 1/3 oz Brush on Gap Filling CA

Hobby CA Super Glue

$3.99
$3.49
 
In Stock
Earn
99
Rewards
Hobbylinc #HLC105. Plastic-Cure Brush-On CA, is a gap-filling CA with an applicator brush in the bottle. The product has a fairly quick setting time as well as good gap-filling properties.
 
(1)
Location : CA Super Glue
Hobbylinc IC-LOC - Blue 1.69 fl oz Medium Strength Thread Locker Hobby CA Super Glue #172
22%
Off

IC-LOC - Blue 1.69 fl oz Medium Strength Thread Locker

Hobby CA Super Glue

$13.99
$10.89
 
In Stock
Earn
310
Rewards
Hobbylinc #HLC172. Threadloc Blue is a medium thickness, medium strength threadlock that is applied to the threads of fasteners before assembly. Once the IC-Loc Blue is cured, the fasteners can be disassembled with standard hand tools if required.
Location : CA Super Glue
Hobbylinc Ultra Cure Tire Glue 3/4 oz Medium #130
17%
Off

Ultra Cure Tire Glue 3/4 oz

Medium

$7.49
$6.19
 
In Stock
Earn
176
Rewards
Hobbylinc #HLC130. This is a 3/4 oz Tire Glue Pocket CA that dries in 5-10 Seconds.
Location : CA Super Glue
Next
Page: 1  |  2  |  3 of 3Top
The #1 Source for Hobby Products!
Help
Account
Cart
x
Close This Window
MORE
Next
Page: 1  |  2  |  3 of 3Top