One Drop Applicator with 2 Tubes

This is the Flex-I-File One Drop Applicator with 2 Tubes hobby and model glue applicator.

Flex-I-File One Drop Applicator with 2 Tubes Hobby and Model Glue Applicator #6003
 (20)
 Flex-I-File # flx6003
$7.59
 
Retail $9.50  SAVE 20% !
Flex-I-File Item # flx6003
  IN STOCK
Website security verified by GoDaddy.

Spotlight Review

 
"Not for Plastic Weld Solvents"
chrislehman05
I bought this hoping to use it as a drop applicator for plat-i-weld and the solvent is way too thin. I then cleaned it out and tryed to use it for CA glue, but it dried up in the tip and the bottle was useless to me. I guess it could be used for something like testors modeling glue, or white glue, but it is absolutely useless for solvent and CA.

You Might Also Like

← Swipe To View More →

Specs

  • Flex-I-File Product Number: 6003

Requirements & Suggestions

← Swipe To View More →

Product Rank


Reviews

  
 
"Use with caution but works"
Full Steam Ahead
I purchased this to use with Plasti-weld. The dropper performed well but you have to be very careful not to squeeze the bottle too long or it will flood the area. It does work well for single drops as long as you watch the flow. With caution during use, I do recommend this.

 
"Very useful when used with touch-n-flow"
CS
I use this primarily to fill the touch-n-flow applicator. This works well to suck glue out of its container. I have also used it to apply glue, but it is not as precise as the touch-n-flow. There's not really much more to say. It works well for what it is, and at $5, I would recommend this

 
"Just a tiny bit"
mmthrax (Plano, TX)
I have one of these for my watery super glue and one for the accelerator. These allow you to only put a dab where you want it. Keeps your project and your bench clean.

Others Also Ordererd

← Swipe To View More →