A rather large model for a bi-plane, the kit goes together rather nicely. Little need for putty to fill seams on the fuselage. Some sanding was needed to smooth out the join lines. The cockpit detail is sparse. Pilots are two well molded torsos and need to be replaced if possible. Careful painting of the pilots will make them acceptable. A full cockpit canopy which includes a rear facing gun is supplied.
The engine detail is wonderful. The pistons are well molded and you get the exhaust ring that is clear visible behind the engine cowl. Propeller stencils are included.
The alignment of the top wing is problematic. I recommend rigging the model beforehand as the box art and directions gives a good idea where the wires go. Aligning the struts to the wings is a bit of a challenge but Pro-weld will alleviate many issues. For rigging, I used a 0.20 gauge music wire cut to size and glued using white tacky glue. Exhaust staining achieved through slight application of Tamiya pastels. I built my model in flight. I had to cut a slot for the borrowed stand and created a cover for where the landing gear would have extended. No parts to do this are supplied with the kit. I used alternate decals for a plane in U.S.M.C. markings.