• 2-piece set consists of the transmitter (TX) and the receiver (RX).
• Allows operation of any DC powered model railroad train as a "wireless walk-around" control system without any modifications to
• existing power supplies or locomotives.
• Fully compatible with any gauge and scale of DC model train.
• Can be used with almost any DC power pack of 2.5 amp or less.
• Easy installation and operation - only 4 wires need to be connected.
• Operational distances of "100" are possible between transmitter and receiver and no "line of sight" is required.
• Set can be used either inside or outside if receiver is protected.
• Flexible antenna.
• "Momentum function" built into controls so that "jack rabbit" starts and stops are eliminated.
• No programming is necessary to begin operation.
• Clear instructions, a limited warranty, and servicing available.

One Basic Train Engineer Walk-Around Control System

• Transmitter (TX): Frequency: 27 MHz
• Band Modulation: FM (Code Type)
• Power Supply: 9 Volt Alkaline Battery (Internal)
• Receiver (RX): Frequency: 27 MHz
• Type of Emission: FM (Code Type)
• Input Voltage: 12 Volt - 22 Volt DC
• Output Control Current: 2.5 amp