• Composite body rotary valve carburetor with 5.5mm bore.:
• Silver colored cooling head.:
• SG (pilot) type crankshaft.:
• Two year limited warranty.:

• Specs such as horsepower, bore, stroke and RPM were not provided- contact HPI for further infomation
• High Speed Needle Setting: Turn clockwise in 1/8 turn increments to lean fuel mixture. Do not exceed 2-1/2 turns from flush
• Idle Adjustment: Adjust for about 0.04 (1mm) gap between slide valve and carb body at bore opening
• Low Speed Needle: No adjustment recommended:
• Displacement: .18 cu in (3.0cc):

HPI Nitro Star G3.0 Engine with Pull Start, instruction manual, R5 cold glow plug (hpig1504), foam air cleaner assembly with four zip ties, brass collet

Distance Between Mounting Holes Same Side: 0.43 (11mm) Distance Between Mounting Holes Opposite Side: 1.22 (31mm) Height/Bottom Mounting Flanges to Top of Cylinder Head: 2.99 (76mm) Height/Bottom of Crankcase to Top of Cylinder Head: 3.5 (89mm) Length from Pull Starter to End of Crankshaft: 4.13 (105mm) Length from Pull Starter to Front Bearing: 3.3 (75.3mm) Length from Center of Crankcase to End of Crankshaft: 2.96 (75mm) Diameter of Carburetor Bore: 0.21 (5.5mm):