• Chassis: TT-01 type E composite chassis-compatible with a variety o Tamiya Option Parts, fiberglass reinforced nylon resin upper deck.
• Drive: Four wheel shaft drive.
• Electronic Speed Control: Tamiya TEU-104BK with reverse, TAMM4541.
• Motor: 540 motor with pre-attached leads.
• Ball Bearings: Installed in differentials, bushings in wheel hubs.
• Shocks: Friction, plastic body.
• Gearbox: Sealed, front and rear.
• Differentials: Bevel gear, ball bearing equipped.
• Transmission: Single speed.
• Body: Clear untrimmed, with window mask and body trim decals.
• Tires: Slick 1.0" (26mm) wide, 2.6" (65.5mm) diameter.
• Wheels: Lace pattern black 2.0" (52mm) outer diameter, 1.0" (26mm wide and set of silver colored 0.94" (24mm) wide, 2.0" (52mm diameter wheels with +2° offset.
• Bumper: Front foam.
• Suspension: Independent double wishbone.
• Camber: Non-adjustable, camber refers to the angle of the tops of th tires from vertical when viewed from front or behind vehicle.
• Caster: Non-adjustable, caster/toe-in refers to the angle of th front suspension when viewed from the side of the car in relatio to the chassis.
• Steering: Bell-crank type with servo saver.

• VEHICLE--
• Length: 15.7" (400mm)
• Width: 7.2" (183mm)
• Height: 5.5" (140mm)
• Wheelbase: 9.9" (251mm)
• BODY-
• Length: 17.5" (445mm)
• Width: 7.6" (194mm)
• Height: 4" (102mm)

Ferrari 599XX 540 motor, ESC, clear body, tires, foam bumper, 19T pinion gear, 61 tooth spur gear, window mask decals, two sets of wheels and instruction manual

For replacement, or to upgrade to Ball Bearings use Qty. Size Locatio Qty. Bearing Se 2 5x11mm Front Hub 1 DTXC154 2 5x11mm Rear Hub 1 DTXC154 2 8x12mm Front Dif 1 DTXC158 2 8x12mm Rear Dif 1 DTXC158 2 5x11mm Fr Driveshaft Joint 1 DTXC154 2 5x11mm Rear Driveshaft Joint 1 DTXC1547.