Hobbico Hand Tools

This is Hobbico's Flexible 18" Ruler. It is Made of Stainless Steel and Should Last a Lifetime. Features: * The ruler is marked in various increments (1/8" through 7/8"). * Made of Stainless Steel.
...more about the Hobbico 18'' Flexible Stainless Steel Ruler

This is the Hobbico 48" Adhesive-Backed Bench Ruler. Features: Both Standard and Metric Measurements.
...more about the Hobbico 48'' Adhesive Bench Ruler

This is a Non-Slip Straight 36" Metal Ruler. Features: Has a Non Slip Rubber Type Back.
...more about the Hobbico 36'' Non-Slip Straight Edge Ruler

This is the All New Retractable Fabric Tape Measure from Hobbico. Features: * Hardshell Blue Plastic Case. * Flexable Tape Strip w/Metal Loop End.
...more about the Hobbico Retractable Fabric Tape Measure

This is the Hobbico Builder's Triangle Set. Features: * Made of Semi-Clear Soft Bendable Plastic. * 2-Piece Set with Interlocking 30, 45, and 60 Degree Triangles. * Interlocking Design Allows Them to Stand Alone to Create and Angle Guide for Squaring in 2 Dimensions. * 45 degree triangle. * Inch scale up to 5" in 1/16" increments. * Thickness gauge 1/8", 3/16", 1/4", 5/16", and 3/8". * 90 degree protractor in 1 degree increments. * 30/60 degree triangle. * Inch scale up to 6" in 1/16" increments. * Metric scale up to 220 mm in 1mm increnments. * 30/60 degree triangle. * Centering gauge. * Corner cut-out for perfect 90 degree alignment.
...more about the Hobbico Builder's Triangle Set

This is the Hobbico Builder's Ruler. Features: * Made of Semi-Clear Soft Bendable Plastic. * Inch Scale up to 6" in 1/16" Increments. * Hole Gauge up to 3/8". * Thickness Gauge up to 3/4". * Circle Template up to a 6" Diameter Circle. * Upright Slot Used to Square Ribs up to 2". * Protractor up to 90 Degrees in 5 Degree Increments. * 45 Degree Angle on one End.
...more about the Hobbico Builder's Ruler 7''

This is the Builder's Protractor. Features: * Ideal for any task requiring precise angle measurements. * Measure right thrust on R/C airplanes: Hold the angle finder on the thrust washer and measure the angle to the left side fuse. * Flip the tool over and measure the angle to the right fuse side. * The difference between the two readings is the thrust angle. * Measure down thrust on R/C airplanes: Block the tail so it is level. * Block up the protractor so it is parallel with the table and line up the pointer with the thrust washer. * The reading will tell you the amount of down thrust the engine has relative to the tail. * Car modelers can use the Builder's Protractor to
...more about the Hobbico Builder's Protractor 8-1/2''

This is a Builder's Metal Templates Set. Features: Use Builder's Metal Templates to true and square up formers, ribs, firewalls, stabilizers, etc. , during construction to ensure that your model builds straight and true.
...more about the Hobbico Builder's Metal Template Set