Same as AR-1, but with adjustable delay to hold train at sensor before reversing. Adjustable delay from one second to over one minute. Can be connected to pushbutton or DT-4 to permit stops and delays without reversing. Requires 12-18V DC power sup ply. Constructed on 3 x 3'' printed circuit
...more about the Circuitron AR-2 Automatic Reverse w/Adjustable Delay
|
Tiny Opto-Sensors detect train movement. Sensors mount between the rails and activate circuitry when shaded from a passing train. Independent of track power, rolling stock requires no modifications. Sensors fit between ties and may be ballasted ove r in most cases. Circuitry is extremely sensitive and will operate properly under very low levels of room light. Positive indication whenever a section of a layout is occupied by rolling stock. Contains all circuitry to power
...more about the Circuitron BD-1 Optical Detector
|
|
|
|
Activates dual-coil switch machine when used with DT-4. Momentary pulse when detection unit is activated, protects from burnout. Can be used to control both directions. Requires 10-18V AC or DC input. The higher the voltage, the greater the output power. Recycle time on each side is 1-2
...more about the Circuitron TC-1 Automatic Turnout Control
|
|
|
|
Timing circuitry for standard traffic light. Outputs drive LED or lamp signals (not included). If LEDs are used, they must be common anode design. All four times are adjustable. Requires 10-18V AC or DC input. Red, yellow and green outputs provided for each direction (six total) and each can drive a 250mA maximum load. Adaptable for all
...more about the Circuitron TL-1 Traffic Light Controller
|
Prototype turnouts don't snap open and closed, they move slowly. This easy-to-mount switch machine features prototypical slow-motion action-three seconds to complete throw. Easy-to-mount slow-motion switch machine features; * Prototypical slow-moti on action - three seconds to complete throw * Precision-engineered gear drive mechanism * Simple mounting with linkage included - no additional brackets or linkage necessary * Convenient auxilliary contacts - two sets SPDT
...more about the Circuitron The Tortoise(TM) Switch Machine
|
Smail (Slow Motion Actuator with Integrated Logic) features same size & mounting as the TORTOISE (sold separately). Compatible with all DCC systems that provide accessory address control. Two-wire connection to DCC bus with no external power ne ary. Easy programming. May also be controlled with panel switches or detection circuits. Adjustable throw speed. Power up position user definable or will default to last used. Other specifications same as TORTOISE
...more about the Circuitron The Smail(TM) Switch Machine w/Internal DCC Decoder -- Single
|
Mounting bracket and mechanism utilize the Tortoise(tm) (not included) and a special drive wire cable assembly to remotely actuate any crossing gate, train order or semaphore signal having a vertical control wire extending below the layout. Positiv e, adjustable stops are provided at both ends of travel. Can drive two cables from the one drive mechanism, if desired. Adjustable for all
...more about the Circuitron Tortoise -- Gate/Semaphore Actuator
|
|
|
|
|
|
|
Plastic assembly provides simple snap-in mounting of all Circuitron printed circuit boards. Prepunched with mounting holes; can be mounted using screws, adhesive or double-backed tape. After PCMT is mounted, circuit boards simply snap into the trac k and can be easily be removed for
...more about the Circuitron Printed Circuit Mounting Track
|
