Easy to put together and fun to fly.. CiCi shows you just what kind of performance you can achieve with a small, simple model. CiCi is great for students or scouts that want to use standard-size motors and want the extra kick of maximum speed and a ltitude. CiCi is as basic to build as Tinee, but you won't mistake CiCi's blinding dash for altitude on a C6-3 motor for a flight by anything else. Laser-cut fuselage and flying surfaces combine with a computer-machined nose cone
...more about the Edmonds Edmonds CiCi Boost Glider
|
|
|
|
Easy to put together and fun to fly.. These familiar triangles find their homes in the skies over flying fields from New England to San Diego. This 1995 design inaugurated the Edmonds Aerospace standards for mistake-proof beginner-oriented kits wit h precision wet die-cutting and realistically illustrated instruction sets. Now laser cutting has only made them better. Your students or scouts will love the little triangles, as they give the best performance of any of my
...more about the Edmonds Edmonds Deltie
|
|
|
|
|
|
Easy to put together and fun to fly.. The Ecee series models give you a sophisticated ride. Ecee gives you a quick introduction to the world of Rocket Glide (R/G) where the model climbs aloft and descends as a single unit. The Ecee uses the Edmonds Canard system for boost, in which the elevator surface on the canard is left to move freely for flight under thrust and coast, but then locked down into position for
...more about the Edmonds Edmonds Ecee Rocket Glider
|
Glide Recovery. . Laser cut parts. . Easy to assemble and fly.. The Ecee series models give you a sophisticated ride. Ecee gives you a quick introduction to the world of Rocket Glide (R/G) where the model climbs aloft and descends as a single unit. The Ecee uses the Edmonds Canard system for boost, in which the elevator surface on the canard is left to move freely for flight under thrust and coast, but then locked down into position for
...more about the Edmonds Edmonds Ecee Thunder
|
|
Glide Recovery. Laser cut parts. Easy to assemble and fly.. A fellow named Mitch Amos once proposed a model made from two separate aircraft that would blast off as a single unit, then split apart to glide in individually. I agreed that it would be a neat trick, and the Geminee series is what I ended up with. The design is a pair of what the engineers call ''tailless'' aircraft, because they have no horizontal stabilizer. They launch in a symmetrical configuration, reach
...more about the Edmonds Edmonds Geminee Boost Glider
|
Glide Recovery. Laser cut parts. Easy to assemble and fly.. A fellow named Mitch Amos once proposed a model made from two separate aircraft that would blast off as a single unit, then split apart to glide in individually. I agreed that it would be a neat trick, and the Geminee series is what I ended up with. The design is a pair of what the engineers call ''tailless'' aircraft, because they have no horizontal stabilizer. They launch in a symmetrical configuration, reach
...more about the Edmonds Edmonds Gemine Thunder
|
|
|
|
Easy to put together and fun to fly.. It's cute and a little bit sporty, but you'll finish assembling your Tinee in less than a half hour, even if you've never built a model before. Thanks to the repeatability of laser cut parts, you can fly Tinee with no adjustments at all. This is the model for your scout troops and school science clubs, as I designed it to be the most mistake-proof and lowest-cost kit that the current state of the art will allow me to produce. Though the
...more about the Edmonds Edmonds Tinee Boost Glider
|
|
