After a few years of waiting, I finally got around to finishing this one. In Tamiya fashion everything just fell right into place. The only thing that took a bit more effort was the roll bar cage since the bars bend a little it wasn't as rigid so setting it in the proper position when glued took some patience. I used Tamiya thin cement on the joints and just held them in place for a few seconds. Note that the engine isn't too detailed, not too many parts. Due to my painting skill level and not wanting things to get ugly, I didn't do the semi-gloss black accents they recommended. I was too worried to mess up my pretty orange spray job. Decals went on with zero issues, just used some decal softener / setter. Warm water for about 30 sec to 1 min then set it on some paper towel and you should be able to slide it right off.