Likes: 23

OOB except for MicroScale decals & HGW seatbelts

Likes: 23

Likes: 23

Likes: 22

Likes: 22

Likes: 23

Likes: 23

Likes: 22

Likes: 21

Likes: 19

Dry fitting of landing gear & engine mount bulkhead. Yes it is really suppose to be at this angle. Don't worry the angle will not be visible once everything is assembled. Dry fit this several time to insure it is correct.

Likes: 21

Don't glue floor, inst panel, side panels & seat bulkhead together first as instructions show. Push instr panel & seat bulkhead into floor & set side panel in place. Hold parts together in position on rt. fuse half. Glue floor 1st with Tamiya Extra Thin. Let cure.Glue remaining parts to fuse half.