Hobbylinc Building Supplies On Sale

Shop online for 5 hobbylinc building supplies on sale at discounts up to 28%.

Sub-Categories for Hobbylinc Building Supplies On Sale

Products of Hobbylinc Building Supplies On Sale


Extra Cyanoacrylate Tops

CA Glue Tip Glue Applicator
$0.79 $0.69
SALE
13% Off
Hobbylinc # hlc312
  Add To Cart
Wish List
Replacement top that is on all of BSI's non-Pocket CAs.

MAXI-CURE Extra Thick Cyanoacrylate 1oz

Hobby CA Super Glue
$6.99 $5.09
SALE
27% Off
Hobbylinc # hlc112
  Add To Cart
Wish List
MAXI-CURE extra thick CA is the best CA for most plastics, including GE's Lexan MAXI-CURE is the best choice for plastic model assembly. When used with INSTA-SET, it works better than any putty for modifying or filling voids. It can be carved with a knife or razor blade and sanded and feathered to form a finish indistinguishable from plastic. MAXI-CURE bonds fiberglass, hardwood, metal and rubber better than any other hobby adhesive. For gluing to the inside, clothtextured surface of fiberglass, scrape the area to be bonded with a razor blade or coarse sandpaper before using MAXI-CURE or any other adhesive. It also is best for bonding the tires for R/C cars.

SUPER_GOLD Gap Filling Insta-Cure 1/2oz

Hobby CA Super Glue
$9.99 $7.19
SALE
28% Off
Hobbylinc # hlc126
  Add To Cart
Wish List
SUPER-GOLD and SUPER-GOLD+ are our odorless INSTA-CURE CAs They are non-frosting and take only 2 or 3 seconds longer to bond.

FINISH CURE 20 Minute Epoxy (13oz)

Hobby Epoxy
$44.99 $32.49
SALE
28% Off
Hobbylinc # hlc210
  Add To Cart
Wish List
FINISH-CURE 20 min. epoxy is an excellent, low odor substitute for polyester resins. It can be used for applying fiberglass cloth to wood or by itself to give wood a surface ready for primer and paint. FINISH-CURE can be sanded the easiest of all our epoxies and is excellent for the sheeting of foam core wings. Allow 8 hours for full curing. For best results, FINISH-CURE should be heated to a temperature above 85 degrees F or applying light weight fiberglass, lay cloth on balsa first, then brush on FINISH-CURE. When fully saturated, go over the surface with a heat gun, and then squeegee off excess epoxy with a playing card from an old deck. Heat and remove excess several times for a light we
SALE
28% Off
Hobbylinc # hlc172
  Add To Cart
Wish List
Threadloc Blue is a medium thickness, medium strength threadlock that is applied to the threads of fasteners before assembly. Once the IC-Loc Blue is cured, the fasteners can be disassembled with standard hand tools if required.
Website security verified by GoDaddy