Reviews : Trumpeter Modeling Clamps (2) with Base
Sort
Reviews
simple, cheap, and they seem to work.
By: GhastlyCo
I picked these up on a whim as I needed a second 'third hand'. They are remarkably simple, and I put them together in two minutes with no tools except my hands. One of the clamps is smooth, and the other has ridges, but they probably will not hold anything very heavy. The clamp stands are held in position by rubber O rings that I bet I can buy for pennies at the local hardware store if these wear out. They are not great looking, but nor are they expensive. They fit a niche and seem to work for me so far. I gather that if you bought more than one set you could add a few clamps to the base (if you needed to).
Disappointing
By: georgiabugman
This item is very light and will require a ballast (I attached mine two a small piece of 2×4) to remain upright while in use. In addition, I had to glue the arms in one position as there was little pressure required at all to make the arms lose position.
work for some parts
it is very handy when you need to haves clamp but the design is not the best but works great for holding 2 sheets together or wires to make wire harnesses
could use improvement
By: dealengr
very poor assembly instructions. Weak clips. stand needs weight. o rings impossible to install. save your money.
light weight
By: gobad3
excellent for light weight projects ... the base bottom could be a little heavier other than that i like it
Extra hands
By: user133466
Found they could use a tad more weight in base. Accomplished this with simple modeling clay.
Needs to be a metal base
Very lite weight from the picture looks great get it not so much