Community > Members > Bill Z. (Forsyth, GA) > Shared Images > AMT # AMTAMT620
(10/6/18), This is part 1 of a 3 part model project. The tractor AMT620 (HobbyLinc) will be coupled with an AMT 880/06 drop deck trailer (out of production) hauling the AMT 1086/06 construction bulldozer (HobbyLinc). As of this writing, the other two parts are not yet completed.
Like 24 Likes
The tractor is airbrushed with Krylon brush on hobby paint custom mixed. The trailer will be the same color.
Like 23 Likes
I felt it necessary to make hoses/cable from the tractor to the trailer when complete.
Like 25 Likes
I used 22ga. bell wire.
Like 24 Likes
Like 22 Likes
Attaching the completed cab was not easy. But it works and tilts just fine.
Like 24 Likes
Since the road grader blade is actually 6" wide, it will hang over the trailer sides and require "Wide Load" markings. One of these is rotating amber lights on the top of the cab (in a real world situation).
Like 23 Likes
And another is a WIDE LOAD banner across the front of the tractor (and the rear of the trailer).
Like 24 Likes
Like 23 Likes
I replicated a truck that used to run the roads years ago. COE tractors are rarely seen these days. This one would be from Chadderton Trucking of Sharon, PA. They are near where I live.
Like 26 Likes
This tractor was a very good project and relatively easy to assemble. Directions are the pits!!
Like 24 Likes