This is the completed Corvette using the original yellow of the plastic. I chose this to give it the effect of a matte finish. This kit comes with no brake calipers, so I copied some pictures of brake caliper covers from the internet and reduced them to the proper scale, printed them on card stock,

You will notice that the lower rear panel is not black but the same color as the car. I think that is a big improvment to the appearance of the rear end.

Here is a closer view of the rear with out the lower panel color the same as the body.

The chrome wheels were painted with Testor's black lacquer.

Here you can catch a glimpse of the racing 5 point belt system.

This Snap Tite is painted in Testor's Flat Red.

This kit has been easily lowered by adding 4 additional axle holes.

A better view of the lowering.

Wheels painted with Eastwood's Argent Silver.

Good view of Testor's Flat Red Enamel Spray.

Rear panel was done in body color to enhance appearance.