Gap Fill CA Super Glue

This is the Pacer Technology 0.25oz bottle of Plasti-Zap Brush-On Medium CA.

INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ should also be used. To prevent premature curing, don't spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.

This is the package of five Pacer Technology 0.01oz (0.5g) Single Use Tubes of Zap-A-Gap CA+ CA Glue.

This is a bottle of 0.25oz (7g) Pacer Technology of Zap-A-Gap Medium CA+ CA Glue.

INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ should also be used. To prevent premature curing, don't spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.

Plastic-Cure Brush-On CA, is a gap-filling CA with an applicator brush in the bottle. The product has a fairly quick setting time as well as good gap-filling properties.