Hot-Shot 2 Standard
This is a Hot-Shot #2 Standard Glo-Starter with Battery Charger. This is used to heat glow plugs while starting glow-powered engines.
Hobbico # hcahcap2520
$16.39
Retail $27.99 SAVE 41% ! | |
Out of Stock Discontinued - No longer available for purchase |
Website security verified by GoDaddy.
You Might Also Like
← Swipe To View More →
Features
- Proven Twist and Lock Connector ensures a secure, solid connectio that won't come off, providing safer, faster starts for your model..
- Pre-Installed Genuine Sanyo Sub-C battery cell.
- Included AC battery charger with hex-shaped charge end recharges the glow starter in 10 hours. A Red LED glows when unit is Charging..
- Removable Red rubber socket cap prevents shorting and any dirt o dust debris from entering into the the shaft..
- One Year Limited Warranty USA and Canada only.
Specs
- Sanyo Sub-C NiCd Battery: 1500mAh, 1.2V
- AC Charger- Input: 110-120V AC 60Hz (US Standard) Output: 1.25V DC 150mA
- Hot Shot- Overall Length: 4" (102mm) Shaft Length: 2-1/4" (57mm) Diameter: 15/16" (24mm)
Includes
- One Hot Shot #2 Standard Glo-Starter w/Red rubber protective cap
- One Hot Shot #2 Glo-Starter Battery Charger
- One Instruction/Header Card
Requirements & Suggestions
← Swipe To View More →
Reviews |
Comments
- How to use: To lock onto your engine's glow plug, place the end o the Hot Shot 2 over the plug and push down. Twist the Hot Shot clockwise and it locks into place..
- Charging: Before using, initial charge should be 12 to 14 hour Subsequent charging time is approximately 10 hours.
- For Hot Shot #2 Long version use HCAP2522.
Others Also Ordererd
← Swipe To View More →