Super Hot-Shot 2
This is a Super Hot-Shot #2 Standard Glo-Starter with Battery Charger. This is used to heat glow plugs to start glow-powered engines.
Hobbico # hcahcap2528
$27.19
Retail $44.99 SAVE 40% ! | |
Out of Stock Discontinued - No longer available for purchase |
Website security verified by GoDaddy.
Features
- Proven Twist and Lock Connector ensures a secure, solid connectio that won't come off, providing safer, faster starts for your model..
- Pre-Installed Genuine Sanyo 5000mAh battery cell.
- Included AC battery charger with hex-shaped charge end recharge the glow starter in 10 hours. A Red LED glows as unit is charging..
- Removable Red rubber socket cap prevents shorting and any dirt o dust debris from entering into the the shaft..
- One Year Limited Warranty USA and Canada only.
Specs
- Sanyo NiCd Battery: 5000mAh 1.2V
- AC Charger- Input: 110-120V AC 60Hz (US Standard) Output: 1.25V DC 500mA
- Hot Shot- Overall Length: 4-5/8" (118mm) Shaft Length: 2-1/4" (57mm) Diameter: 1-5/16" (33mm)
Includes
- One Super Hot Shot 2 Standard Glo-Starter w/Red rubber protective cap
- One Hot Shot #2 Glo-Starter Battery Charger
- One Instruction/Header Card
Requirements & Suggestions
← Swipe To View More →
Reviews |
Comments
- How to use: To lock onto your engine's glow plug, place the end o the Hot Shot 2 over the plug and push down. Twist the Super Ho Shot #2 clockwise to lock into place..
- Charging: Before using, initial Charge should be 12 to 14 hour Subsequent charging time is approximately 10 hours.
- For Hot Shot #2 Standard version use HCAP2520.
- For Hot Shot #2 Long version use HCAP2522 Note:*** The charger originally packaged with this Glo-Starter has a 150mA Charge rate which requires a long time to Charge the large mA battery. The modeler Charges the battery initially for 24 hours After that, 12-hour Charges each. If modeler is a regular flier Charge twice a month for 24 hours. ** JAL 8/20/9 ir/jl.