INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ should also be used. To prevent premature curing, dont spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.
Product Features
INSTA-CURE+ is a gap filling glue that dries in 5-15 sec.
Awesome glue. Thin enough to use as a seam filler for small gaps. Can be sanded smooth after cured. My go to glue
Was this review helpful to you?
42 of 42 people found this review helpful
Insta-Cure Gap Filling CA 2 oz
By mooniemac2000
May 2, 2015
This is CA glue, an extremely strong adhesive. This glue has a high viscosity so it flows slower. This glue is great because it does not leave any noticeable residue. Back in my rookie days in modeling, I messed up when I used nail glue, which also has CA, but left CA residue on the clear part. This residue is ver hard to get out, and ruins clear parts. I also used to use CA for decals (dumbo!). The former statements is what makes this CA glue suitable for modeling.
Was this review helpful to you?
38 of 38 people found this review helpful
Super Glue for the Job
By johncpo41
January 13, 2015
This product has always been by choice the best for all of my models since it was on the market. The gap filling is most used for fuselage and wing gap filling with the best results. Nothing else takes the place of this glue.
Was this review helpful to you?
38 of 38 people found this review helpful
CA glue
By tulowstar45
January 11, 2016
As you can tell I use this alot by ordering a 2 ounce bottle. I use it almosty exclusivly on building model rockets
Was this review helpful to you?
37 of 37 people found this review helpful
(51)
