1/10 Mercedes AMG DTM C Class 2008 Kit

• Chassis: TT-01 type E with shock tower now molded separately fro the gear case covers and new upper deck with transponder mount new A parts (Uprights) made of polycarbonate plastic material new D parts (upper deck, motor cover and more) made of fiberglass reinforced nylon material.
• Drive: Four wheel shaft drive.
• Motor: 540 size with pre-attached leads.
• Electronic Speed Control: Tamiya TEU-101BK.
• Lights: Tamiya TLU-01 (TAMC1394) LED light unit with four LED lights see COMMENTS.
• Shocks: Friction, not oil-filled, composite body.
• Gearbox: Sealed front and rear.
• Differentials: Bevel gear.
• Transmission: Single speed.
• Tires: Racing slicks 1.02" (26mm) wide, 2.48" (63mm) diameter.
• Wheels: 16-spoke plastic 1.02" (26mm) wide, 2.04" (52mm) diameter gray in color.
• Body: Lightweight polycarbonate, requires trimming and paintin injection molded side mirrors and rear wing.
• Bumpers: Foam front bumper.
• Suspension: Four wheel independent double wishbone.
• Camber: Non-adjustable, camber refers to the angle of the tops of th tires from vertical when viewed from front or behind vehicle.
• Steering Tie Rods: Fixed non-adjustable, caster/toe-in refers to th angle of the front suspension when viewed from the side of the ca in relation to the chassis.
• Steering: Bell-crank TA-05 type with servo saver.
• Servo Saver: Included.

• VEHICLE-
• Length: 17.5" (444mm)
• Width: 7.4" (187mm)
• Height: 5.2" (132mm)
• BODY-
• Length: 17.5" (444mm)
• Width: 7.48" (190mm)
• Height: 4.2" (107mm)

Tamiya Mercedes AMG 2008 DTM C Class, friction shocks, 540 motor, electronic speed control, clear body, tires, foam bumper, wheels 19 tooth pinion gear, 61 tooth spur gear, instructions, LED light unit, window mask and body trim decals