RC Nissan R390 GT1 TT01E

• Chassis: TT-01 type E composite chassis-compatible with a variety o Tamiya Option Parts.
• Drive: Four wheel shaft drive.
• Electronic Speed Control: Tamiya TEU-105BK with reverse, TAMC5055.
• Motor: 540 motor with pre-attached leads.
• Ball Bearings: Installed in differentials, bushings in wheel hubs.
• Shocks: Friction type (not oil-filled), plastic body.
• Gearbox: Sealed, front and rear.
• Differentials: Bevel gear, ball bearing equipped.
• Transmission: Single speed.
• Body: Clear untrimmed, with window mask and body trim decals.
• Tires: Rubber radial 0.94" (24mm) wide, 2.5" (63.5mm) diameter.
• Wheels: Two sets, +2° offset, lace pattern silver in color, and lace pattern in gray with no offset, both 2.0" (52mm) outer diameter 0.94" (24mm) wide.
• Bumper: Front foam.
• Suspension: Independent double wishbone.
• Camber: Non-adjustable, camber refers to the angle of the tops of th tires from vertical when viewed from front or behind vehicle.
• Caster: Adjustable, caster/toe-in refers to the angle of th front suspension when viewed from the side of the car in relatio to the chassis.
• Steering: Bell-crank type with servo saver.

• VEHICLE-
• Length: 15.7" (400mm)
• Width: 7.2" (183mm)
• Height: 5.5" (140mm)
• Wheelbase: 10.1" (257mm)
• BODY-
• Length: 16.8" (427mm)
• Width: 7.5" (190mm)
• Height: 3.6" (92mm)

TT-01 Type E chassis, 540 motor, ESC, clear Nissan R390 body, tires, foam bumper, 19 tooth pinion gear, 61 tooth spur gear, window mask decals, two sets of wheels and instruction manual