Building Supplies

This is the Atlas-Brush Camel Hair 5-piece Brush Set hobby and model paint brushes.

This is a 250ml Bottle of Tamiya color Acrylic Paint (Thinner).

Replacement top that is on all of BSI's non-Pocket CAs.

This is the 1.35fl oz (40ml) Bottle of Tamiya Panel Line Accent Paint in Clear Black.

Extra-thin plastic model cement with applicator brush. Used to glue parts already held together. The thin glue will wick into the joint for a firm bond.

This is the 35ml Bottle Mud & Sand Pigment Powder Set (4 Colors) from Vallejo Acrylics.

180ml Spray Can of Tamiya's Surface Primer L (Gray) for Plastic and Metal.

This is a Grip-On Knife (Assorted Colors) from Excel.

23ml Jar of Tamiya XF-1 Black color Acrylic Flat (Matt) Paint.

This is a 1/4oz (7.5ml) glass jar of Enamel Paint from Testors.

180ml Spray Can of Tamiya's Surface Primer L (White) for Plastic and Metal.

This is a 5/8oz Tube of Cement for Plastic Models from Testors. For Ages 8 and Up.

23ml Jar of Tamiya XF-2 White color Acrylic Flat (Matt) Paint.

This is the Vallejo 17ml Bottle WWII American Armour & Infantry Wargames Paint Set (6 Colors).

180ml Spray Can of Tamiya's Fine Surface Primer L (Gray) for Plastic and Metal.

INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ should also be used. To prevent premature curing, don't spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out. .

Plastic Model glue with applicator brush.

This is a 1/4oz (7.4ml) Glass Jar of Semi-Gloss Black Enamel Paint from Testors.