MIP or Iwata Building Supplies

This is a 1.5mm Thorp Hex Driver from MIP. MIP has picked up the Thorp hex drivers to carry on the tradition of quality that the old Thorp ball end drivers brought you.

This is the Eclipse HP-CS Airbrush from Iwata Medea.

This is the Speed Tip 1.5mm Hex Wrench from MIP.

This is a 3mm Thorp Hex Driver from MIP. MIP has picked up the Thorp hex drivers to carry on the tradition of quality that the old Thorp ball end drivers brought you.

This is the Neo Series Gravity Feed Dual Action Airbrush from Iwata.:.

This is the Revolution 4500 CR Airbrush from Iwata Medea.:.

This is a 3/32" Thorp Hex Driver from MIP. MIP has picked up the Thorp hex drivers to carry on the tradition of quality that the old Thorp ball end drivers brought you.

This is a 2.5mm Thorp Hex Driver from MIP. MIP has picked up the Thorp hex drivers to carry on the tradition of quality that the old Thorp ball end drivers brought you.

This is a Quickfit Quick Disconnect Set from Iwata.

This is the 0.35mm Needle for Iwata Neo Series Airbrushes.

This is the O-Ring for use on the Iwata-Madea Eclipse Airbrush.

This is the replacement Eclipse Needle .35mm for use with the Iwata BCS/BCR/CR Airbrushes.

This is the 0.35mm Nozzle for Iwata Neo Series Airbrushes.

This is the replacement Eclipse Needle .5mm for use with the Iwata BCS/BCR/CR Airbrushes.

This is a 10' Braided Air Hose from Iwata-Medea.

This is the replacement Nozzle .5mm for use with the Iwata BCS/BCR/CR Airbrushes.

This is the replacement Nozzle .35mm for use with the Iwata ECL/BS/CS/SBS Airbrushes.