Building Supplies

Testors #TES9131. This is a Testors Military Flat Enamel Paint Kit. Used for Decorating and Camouflaging Tanks, Ships, Planes & Figures of Nations.

Tamiya #TAM87064. 180ml Spray Can of Tamiya's Fine Surface Primer L (Gray) for Plastic and Metal.

Tamiya #TAM87038. Extra-thin plastic model cement with applicator brush. Used to glue parts already held together. The thin glue will wick into the joint for a firm bond.

Hobbylinc #HLCKIT-03. Supplies that picture-perfect model. The best of everything for building the highest quality models. Great gift for the experienced modeller.

K-S #K+S1146. This package includes Five Tubes of 5/32 Round Brass Tubes by K&S Engineering.

Testors #TES3505X. Wood model glue.

Tamiya #TAM81302. 23ml Jar of Tamiya XF-2 White color Acrylic Flat (Matt) Paint.

Tamiya #TAM87012. Plastic Model glue with applicator brush.

Badger #BAD50-0052. This is a 3/4 Oz. Glass Paint Jar with Cover from Badger.

K-S #K+S501. This Package Includes Five Tubes of .032 Music Wire by K&S Engineering.

Testors #TES4768. This is a 1/2 oz (14.7mL) glass jar of Flat Black Acrylic Paint from Testors.

Woodland #WOOS191. Ready to use matte-medium that is a multi use product for Ballast, Turf, etc.

Tamiya #TAM87044. 180ml Spray Can of Tamiya's Surface Primer L (White) for Plastic and Metal.

Plastruct #PLS00002. This is a Plastic Weld Cement from Plastruct.

Tamiya #TAM87034. This is a 10 Meter Roll of 10mm Tamiya Masking Tape Refill.

Testors #TES1260. This is a 3 oz. (85 g) can of Clear Flat Lacquer Overcoat Spray Paint.

Hobbylinc #HLC103. INSTA-CURE has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam. At the moment CAs cure, they give off a vapor that can irritate the nose and eyes, so be prepared. Thin CAs work very well on balsa since they penetrate into the wood and form more than just a surface bond. .

Testors #TES3503X. Wood model glue.

Hobbylinc #HLC109. INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ should also be used. To prevent premature curing, dont spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out. .

Revell-Monogram #RMX887681. This is the 3mm x 12" x 24" Birch Plywood from Revell.