Glues On Sale

This is a Plastic Weld Cement from Plastruct.

INSTA-SET is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization.

This is the Flex-I-File Touch-N-Flow Applicator hobby and model glue applicator.

INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ should also be used. To prevent premature curing, dont spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out. .

Pacer ZIP KICKER Super-Glue Accelerator is the best working accelerator for ZAP and Other Super Glues. A Little Spritz Works in Seconds.

This is the 1oz bottle of Plastic Weld from Squadron Products.

This is the Testors 5/8oz. Tube Plastic Cement replaces.

For use over BSI's standard #312 top. Can be used with all thicknesses of CA except IC-Gel. The flexible tip can be cut to the length and/or inside diameter that is needed for a particular application.

This is the Flex-I-File One Drop Applicator with 2 Tubes hobby and model glue applicator.

This is the Deluxe-Materials Foam 2 Foam Adhesive (1.7oz 50ml) hobby and plastic model foam glue.

This is the Revell-Germany 13g Tube Cement plastic model cement.

Extra thin Super-Glue for bonding tight-fitting parts.

This is the Testors Cement for Plastics 5/8oz.

INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ should also be used. To prevent premature curing, don't spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.

This is 2oz bottle of Pacer Foam Safe Kicker with Pump.

This is the Deluxe-Materials Speedbond Woodworking adhesive (17.6oz 500g) hobby and model wood glue.