the plane i got did have a molding flaw on my right side main wing where the fuselage and wing meet. this left a hole in the top of the wing and the snap mounts where simply not there probably an air bubble in the mold. don't know if this is a big problem or simply my luck. I was able to glue the wing on and puddy and paint the hole. My real only hassle with the kits design is the landing gear. The gear doesn't want to go in i almost snapped both of them putting them in. there is a slot in the slot is a hole on one side and open slot on the other side. you must twist the landing gear in the slot so the stub of the landing gear goes into the hole 1st then twist the gear hard into the open slot. so be very careful installing the gear. other than that it's a descent kit. The gun turrets rotate the props rotate and the landing gear folds. the only thing missing was the tail guns which i just made from plastic shavings. so there you have it wish the best of luck to you on your kit.
Was this review helpful to you?
18 of 18 people liked this