RC Volkswagen Golf24 4WD On-Road TT-01E Kit

• Chassis: TT-01 type E composite chassis-compatible with a variety o Tamiya Option Parts.
• Drive: Four wheel shaft drive.
• Electronic Speed Control: Tamiya TEU-105BK with reverse.
• Motor: 540 motor with pre-attached leads.
• Ball Bearings: Installed in differentials, bushings in wheel hubs.
• Shocks: Friction, plastic body.
• Gearbox: Sealed, front and rear.
• Differentials: Bevel gear, ball bearing equipped.
• Transmission: Single speed.
• Body: Clear untrimmed, with window mask and body trim decals.
• Tires: Slick 1.0" (26mm) wide, 2.6" (65.5mm) diameter.
• Wheels: Matte chrome 2.0" (52mm) outer diameter, 0.94" (24mm) wid +2° offset and gray colored set with zero offset.
• Bumper: Front foam.
• Suspension: Independent double wishbone.
• Camber: Non-adjustable, camber refers to the angle of the tops of th tires from vertical when viewed from front or behind vehicle.
• Caster: Non-adjustable, caster/toe-in refers to the angle of th front suspension when viewed from the side of the car in relatio to the chassis.
• Steering: Bell-crank type with servo saver.

• VEHICLE-
• Length: 15.7" (400mm)
• Width: 7.2" (183mm)
• Height: 5.5" (140mm)
• Wheelbase: 10.1" (257mm)
• BODY-
• Length: 16.8" (426mm)
• Width: 7.4" (188mm) at widest point
• Height: 4.5" (114mm)

Volkswagen Golf24 on road kit, 540 motor, ESC, clear body, tires, foam bumper, 19 tooth pinion gear, 61 tooth spur gear, window mask decals, two sets of wheels and instruction manual